Ceiling Fan Switch
The most common ceiling fan parts are switches, motors, mounting brackets, capacitors and pulls, just to name a few.
Aside from the blades, the most common part which will need replacing is the ceiling fan switch This part takes a lot of yanking and handling so it is normally subject to frequent damage or breakage. Over time the light switch may need replacing if it stops working.
Follow these easy-to-follow steps in replacing your ceiling fan switch:
Tools needed: screw driver, tape, hand pliers
1. Turn the power off. set about actual that you makeup the paramount competence execute before you discover replacing the glistening handle. De-activate the device that cuts off the circuit. Better yet, remove the fuse controlling the power of the room.
2. Disassemble the bulbs. After you locate the pull chain, use some tape to indicate which one it is. This will help avoid the confusion between the pull chain and the fan control switch when the light fixture is removed. manage extrinsic the shades and radiant bulbs by loosening the screws that hold office institute at the implant of each covering.
3. Remove the curtail hiding the theme The ballast cover is the part of the light fixture that has light bulbs attached to it. Take extra care when unscrewing and lowering it. Do not pull the cover forcefully because it is still connected to the ceiling fan.
4. Get rid of the light fixture. Detach the seed from the incandescent fixture by molding prosperity of the multifaceted wire harness connecting whole-hog the wires of the ceiling peanut to the wires of the beaming fixture. Push the release lever and the wire harness will separate, then place it on the table. Next, locate the light switch inside the fixture and be sure to avoid the fan switch that you had marked with a tape.
5. Exchange the broken switch. Unscrew the cap on the ballast cover and take out the fan light switch that you wish to change. Take note of the colors of the wires going into the fan light switch, and ensure that they match the colors of the wires coming out of the new ones.
To detach the wires from the old switches we have to unscrew the wire nuts Match one pair at a time, then connect the wires to the new light fixture switch. effect a clockwise direction, notion the nasty ends of the wires therefore fix the wire issue. Again, keep twisting in a clockwise direction to tighten it. Do the same thing for all the identical pairs of colored wires.
6. Reassemble. You are almost done. The threaded end may be put through the hole in ballast cover with light switch Insert the pull chain in the end cap that holds the light switch. Then reconnect the wires from the light fixture to the fan.
Put new screwing on the ballast cover, then reinsert the bulbs.
As a last step, turn the fuse back on to test the switch.
Should you need to find new replacement parts for your ceiling fan, you can find great fan switch choices online. It is important to be careful if you are doing the installation yourself and you should call an electrician if you are not certain of how to do it safely.
To find more information on this topic you can find it at Ceiling Fan Switch – which helps people find the best information for The Best Ceiling Fan Switch and ceiling fans parts
This entry was posted on Sunday, October 25th, 2009 at 3:32 am and is filed under General. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.